EasyManuals Logo

Windsor chariot iScrub 20 CSXC20 User Manual

Windsor chariot iScrub 20 CSXC20
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
38
Maintenance
Replacing or Installing Scrub Brushes
(Disk)
FOR SAFETY: Before leaving or servicing the machine;
stop on level surface, turn OFF machine and remove
key.
1. Turn machine power off.
2. Open access cover on deck shroud.
3. Locate release lever, press release lever towards
front of machine to release brush pad. The pad will
drop down when released. Lift deck shroud up and
slide brush/pad assembly out.
4. Remove brush/pad from holder and replace with
new brush/pad.
5. To reinstall, lift deck shroud upward as shown.
Center the brush/pad driver under the brush drive
hub.
Raise brush/pad until it contacts brush driver
assembly. Turn clockwise until release lever plate
locks into position.
6. Check that release lever/plate is completely closed
and pad/brush is securely attached.
NOTE: Damage to driver or brush could occur if not
securely attached.
Brush Release Lever
86333220 CS20

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Windsor chariot iScrub 20 CSXC20 and is the answer not in the manual?

Windsor chariot iScrub 20 CSXC20 Specifications

General IconGeneral
BrandWindsor
Modelchariot iScrub 20 CSXC20
CategoryScrubber
LanguageEnglish

Related product manuals