15
Before You Start
The appliance should be placed in a location where the ambient temperature is between
60-80° Fahrenheit. If the ambient temperature is above or below this range, the
performance of the unit may be affected. For example, placing your unit in extreme cold
or hot conditions may cause interior temperatures to fluctuate.
Setting the Temperature Control
NOTE: The temperature readout shows the actual cellar temperature, it will
temporarily show the set temperature while making adjustments then reverts back
after 5 seconds.
1. Make sure power cord is connected to a properly grounded outlet.
2. Turn power ON.
3. Dual Zone Models: Use the Zone Select button to select the Upper or
Lower zone. Upper zone must be set 4°F colder than lower zone.
4. Set the desired temperature by pushing the Temp UP or DOWN button.
5. Temperatures increase or decrease 1°F with each push of the UP or
DOWN button.
NOTE: Temperatures may fluctuate depending on whether the interior light is ON
or OFF and depending on the position of the bottles.
Lock or Unlock the Control Panel
To LOCK the control panel:
1. Single Zone: simultaneously press the POWER and LIGHT buttons for 3
seconds.
Dual Zone: press and hold the LOCK button for 3 seconds.
2. The control panel will beep and the LOCK icon will illuminate
To UNLOCK the control panel:
1. Touch the control panel to wake it up from sleep mode
2. Single Zone: simultaneously press the POWER and LIGHT buttons for 3
seconds.
Dual Zone: press and hold the LOCK button for 3 seconds.
3. The control panel will beep and the LOCK icon will darken