Wine Enthusiast Beverage Center User Manual

5
Electrical Requirement
• Make sure there is a suitable power Outlet (115 volts, 15 amps outlet) with
proper grounding to power the appliance.
• Avoid the use of three plug adapters or cutting off the third grounding in order to
accommodate a two-plug outlet. This is a dangerous practice since it provides no
effective grounding for the appliance and may result in shock hazard.
Install Limitations
• Do not install your appliance in any location not properly insulated or heated e.g.
garage etc. Your appliance was not designed to operate in temperature settings
below 60° Fahrenheit.
• Select a suitable location for the appliance on a hard even surface away from
direct sunlight or heat source (e.g. radiators, baseboard heaters, cooking
appliances etc.). Any floor unevenness should be corrected with the leveling legs
located on the front and rear bottom corners of the appliance.
• This appliance is designed for free standing installation or can be recessed into
cabinetry.
Use of Extension Cords
• Avoid the use of an extension cord because of potential safety hazards under
certain conditions. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade grounding plug and a 3-slot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
Appliance Features and Use
Initial Setup
• Before connecting the appliance to the power source, let it stand upright
for approximately 24 hours. This will reduce the possibility of a malfunction in
the cooling system from handling during transportation.

Wine Enthusiast Beverage Center Specifications

General

Brand	Wine Enthusiast
Model	Beverage Center
Category	Wine Cooler
Language	English