How to troubleshoot Wine Guardian D200 Wine Cooler that does not start?
If your Wine Guardian Wine Cooler unit doesn't start, make sure the switch is turned on. Also, check the circuit breaker and wiring. Ensure the unit is properly plugged in.
How to troubleshoot low humidity with humidifier in Wine Guardian D200?
If the humidity is too low with your optional humidifier in Wine Guardian Wine Cooler, check the wiring for loose, broken, or frayed connections. Verify the humidistat setup and check for water flow and solenoid valve operation. Also, check if the water is hot, inspect the drip pad (replace if scaled), and ensure there's a vapor barrier around the cellar.
How to increase humidity in Wine Guardian D200 Wine Cooler?
To address low humidity without an optional humidifier in your Wine Guardian Wine Cooler, consider adding a Wine Guardian humidifier or a room humidifier to introduce moisture into the cellar.
What to do if Wine Guardian D200 is leaking water?
If your Wine Guardian Wine Cooler is leaking water, it might be due to several reasons. The piping from the unit to the drain could be trapped, requiring you to re-pipe to remove external traps. Alternatively, the trap or condensate pan might be plugged, necessitating cleaning. Ensure the unit is level by using shims if needed.
Why Wine Guardian D200 Wine Cooler supply air is not cold enough?
If your Wine Guardian Wine Cooler unit is operating and blows evaporator air, but the supply air isn't colder than the return air, it could be due to several factors. Check the thermostat setup. Ensure the condenser airflow isn't blocked by cleaning the filter and coil if necessary. If the head pressure (HP) switch is open, remove any blockage. If the high pressure switch is open, reset the HP switch.
How to reduce noise from Wine Guardian D200?
If the sound of the Wine Guardian Wine Cooler is objectionable, redirect the airflow. You can also try adding baffles, insulated ductwork, or a sound baffle between the unit and the occupied space to reduce noise.
Why is Wine Guardian D200 Wine Cooler too cold?
If the cellar temperature is too cold (below 51°) when your Wine Guardian Wine Cooler unit is running, reset the thermostat to a higher cooling temperature. If you have a heating coil, check for a temperature rise across it. Also, ensure the thermostat is not set too low for heating and is mounted in a proper location.
Why is thermostat light off on Wine Guardian Wine Cooler?
If the power switch light is on and the thermostat light is off on your Wine Guardian Wine Cooler, check the main control board for L.E.D. indication. Inspect the wiring for loose, broken, or frayed connections and ensure proper splicing. The remote interface controller may also be faulty.
General| Capacity | 200 bottles |
|---|---|
| Humidity Control | Yes |
| Power Supply | 115V, 60Hz |
| Refrigerant | R134A |
| UV Protection | Yes |
| Shelves | Wooden shelves |
| Energy Efficiency | Energy Star certified |
To Next Page
