What to do if the high pressure switch has shut down my Wine Guardian wine cooler?
If the high pressure switch has shut down your Wine Guardian wine cooler, it is likely that an obstruction is restricting airflow. Remove any obstructions in the duct or grille, or clean the filter. After that, restart the unit by resetting the high pressure switch.
Why is my Wine Guardian wine cooler leaking water?
If your Wine Guardian unit is leaking water, possible solutions include cleaning the trap, removing any blockages, and ensuring the unit is level using shims.
What to do if the cellar temperature is too high in my Wine Guardian, but the supply air is cold?
If the cellar temperature is too high, but the supply air is cold, you can try removing any blockage in the supply or return ductwork. Also, check and clean the filter and coil. As an additional measure, you can shut off the unit for two hours.
What should I do if the humidity is too high in my cellar and my Wine Guardian wine cooler is running but not cooling?
If the humidity is too high while your Wine Guardian unit is running but not cooling, try these steps: Check and reset the high limit switch. Clear any blockage of condenser airflow. Reduce the temperature or draw condenser air from another space.
How to fix a Wine Guardian wine cooler when the cellar temperature is too low while the unit is running?
If your cellar temperature is too low (below 51[0]) while the Wine Guardian unit is running, you can try the following: Reset the thermostat to a higher cooling temperature. Check for temperature rise across the coil. Reset the thermostat to a higher heating temperature. Replace the wiring.
What to do if my Wine Guardian wine cooler blows evaporator air, but the supply air isn't colder than the return air?
If your Wine Guardian unit is operating and blows evaporator air, but the supply air is not colder than the return air from the cellar, check the thermostat setup in the manufacture’s thermostat guide. You may also need to reset the HP switch.
Why is the humidity too high when my Wine Guardian wine cooler is running and cooling?
If the humidity is too high when your Wine Guardian unit is running and cooling, it may be due to poor vapor barrier installation. You can also refer to the Humidifier instructions or add a dehumidifier to the surrounding space.
What to do if humidity is too low in my cellar and my Wine Guardian wine cooler has an optional humidifier?
If the humidity is too low, and your Wine Guardian unit has an optional humidifier, check the wiring for loose, broken, or frayed connections. Also, check the humidistat setup, check for water flow and solenoid valve operation, and check the damper operation.
How do I fix a Wine Guardian wine cooler if the power switch light is off?
If the power switch light on your Wine Guardian wine cooler is off, first turn on the switch. If that doesn't work, check the circuit breaker and wiring. Also, make sure the unit is plugged in.
How to reduce noise from my Wine Guardian wine cooler when it's running?
If your Wine Guardian unit is running properly, but the sound is objectionable, try redirecting airflow, adding baffles, or adding insulated ductwork.
Explanation of safety messages, common hazards (electrical, moving parts), and essential precautions.
Essential safety step to de-energize the unit and safe operation of the main power switch.
Steps for connecting the condensate drain, wiring the unit, and installing/setting the thermostat.
Checklists for receiving, handling, installation, and initial unit readiness.
Steps for powering on the unit, testing fan, initial running checks, settings, and airflow.
General| Voltage | 115V |
|---|---|
| Refrigerant | R-134A |
| Lock | Yes |
| UV Protection | Yes |
| Type | Wine Cooler |
| Shelves | Wooden |
| Door | Glass |
To Next Page