What to do if my Wine Guardian wine cooling system unit does not start up?
If your Wine Guardian unit isn't starting, there are several things to check: * Ensure the voltage switch is in the correct position. * Verify that the unit is plugged in. * Check the circuit breaker and wiring to ensure there is power to the outlet. * Reset the LCDI if it has tripped.
What to do if my Wine Guardian wine cooling system cellar temperature is too high, but the supply air is cold?
If your cellar temperature is too high even when the supply air is cold, consider the following: * There might not be enough evaporator airflow. Remove any blockages in the supply or return. * The cellar heat loads could be too high. Check and clean the coil. * The coil might be frozen. Shut off the unit for two hours, install additional insulation, or replace with a larger-sized unit.
Why is humidity too high when my Wine Guardian wine cooling system unit is running, but not cooling?
If the humidity is too high when your Wine Guardian unit is running but not cooling, it could be due to: * The compressor not operating. Check and reset the high limit switch. * The ambient temperature being too high. Clear any blockage of condenser airflow or reduce the temperature by drawing condenser air from another space.
Why is humidity too high when my Wine Guardian wine cooling system unit is running and cooling?
If you experience high humidity while your Wine Guardian unit is running and cooling, the cause may be: * Too much moisture in the cellar. * Check for poor vapor barrier installation. * Refer to the humidifier instructions for humidifier malfunction. * Consider adding a dehumidifier to the surrounding space.
What to do if the supply air from my Wine Guardian wine cooling system is not colder than the return air?
If the supply air isn't colder than the return air, check these potential issues: * The thermostat might not be set up properly. Refer to the manufacturer’s thermostat guide. * The compressor might not be operating. Check if the high-pressure switch is open. * The condenser airflow might be blocked. Remove any blockage. * The Head Pressure (HP) switch might be open. Reset the HP switch – see reset instructions on page 45.
Why is humidity too high when my Wine Guardian wine cooling system unit is not running?
If the humidity is too high when your Wine Guardian unit is not running, it could be that the system needs to run to dehumidify. Try lowering the room temperature setpoint and sealing openings around doors with a gasket and sweep.
Why is my cellar temperature low (below 51°) when my Wine Guardian wine cooling system unit is running?
If your cellar temperature is below 51° while the unit is running, it could be due to: * The thermostat being set too low on cooling. Reset the thermostat to a higher cooling temperature. * The thermostat not controlling the temperature. The wiring integrity may be compromised (shorted), replace the wiring.
Why is my cellar temperature too cold (below 51°) when my Wine Guardian wine cooling system unit is not running?
If your cellar temperature is too cold when the unit isn't running, it may be due to too much heat loss to adjacent spaces. Increase insulation around the ductwork and doorways, and consider adding a heater.
What to do if humidity is too low, without optional humidifier, in my Wine Guardian wine cooling system?
To address low humidity without a humidifier in your Wine Guardian system, add a Wine Guardian humidifier or a room humidifier, as the cause is likely no moisture being added to the cellar.
Why is my Wine Guardian wine cooling system leaking water?
If your Wine Guardian system is leaking water, it could be due to: * A plugged condensate pan. Remove the blockage and clean the pan. * The unit not being level. Use shims to level the unit.
General| Type | Wine Cooler |
|---|---|
| Power Consumption | 150 watts |
| Refrigerant | R134a |
| Voltage | 115V |
| Lock | Yes |
| Temperature Range | 40°F - 65°F |
| Door | Double-paned glass door |
To Next Page