1.
2.
3.
4.
1
Quick Setup for One Receiver
Make sure the Pathway
®
X1 antenna is in a location with a
clear view of the southern sky.
Connect the primary receiver to the “MAIN” port on the base.
After connecting the receiver to a power source, complete
receiver setup. Select the state that you are currently in.
Then, press “Scan” to start scanning for satellites.
Watch TV!
Specifications
Compatible with DISH programming
Compatible with DISH Solo HD receivers
Supports up to two receivers
For stationary use only
Includes 25 ft coaxial cable
Unit weight: 10 lbs
Unit height (without feet): 13.5 in
Unit height (with feet): 14.2 in
Diameter: 14.3 in
Elevation range: 18–65°
UV-protected plastic dome
Gray plastic base
Made in USA
Compatible Receivers
The Pathway X1 antenna must be used with DISH Solo HD
receivers. Examples of DISH Solo HD receivers include DISH
211z, 211k, 211, and 411 receivers.
Compatible Satellites
The Pathway X1 antenna can receive programming from DISH
western arc, which includes satellites 110°, 119°, and 129°.
See maps* below to determine coverage in various areas of
the United States. Coverage maps are approximate and do
not guarantee coverage.
DISH Satellite 110°
DISH Satellite 119°
DISH Satellite 129°
*Source: www.satbeams.com. Coverage maps are approximate and do not guarantee coverage.
Signal Strength
Good
Best
Dome
Eyelet
Sec.
port
Handle
(“WINEGARD” facing up)
Base
Main
port
To Next Page
Loading...
Need help?
General