3
Receiver setup instructions are accurate at time of printing and may
change without notice.
1.
2.
3.
4.
5.
6.
7.
4.
DISH Receiver Setup
After connecting the antenna to the receiver(s), connect the
receiver to a power source, and complete receiver setup.
Receiver setup for the primary receiver follows; if setting
up with a secondary receiver, see “Receiver Setup for a
Secondary Receiver” on page 5.
Check out online receiver setup guides for your antenna at
www.winegard.com/receivers/setupguide.php.
If using a brand new receiver, follow the steps under
“Receiver Setup for New Receivers.” If using a receiver that is
currently active or has been previously used, follow the steps
under “Receiver Setup for Currently Active or Previously
Used Receivers.”
Receiver Setup for New Receivers
If using a new receiver with the Pathway X1 antenna, the
receiver will go through an Installation Wizard to help with the
setup process.
Follow the on-screen instructions to program the remote control.
During step 2 of the Installation Wizard, the unit will need to
acquire satellites and update the receiver (see fig. 1).
This step will require a search initiated by the Mobile Setup
screen. Fill in the required information, and then select “Scan”
to begin the search routine (see fig. 2).
During the search routine, the antenna will scan for
satellites. The antenna may make a slight grinding sound
when searching for satellites; this is normal and does not
harm the unit. Once the search routine is complete, the
receiver will update.
The receiver may reboot automatically as part of the update
process. If so, select the state of your current location on the
Mobile Antenna Setup screen as in figure 2. Press “Scan” to
begin the search routine.
The satellite will search for and acquire satellites.
If not already activated, the receiver will need to be activated
(see fig. 3). To activate the receiver, call Winegard Company at
1-866-609-9374.
After the receiver has been activated, the receiver will begin
acquiring signal (see fig. 4) and downloading the Electronic
Programming Guide (see fig. 5). Once the download is
complete, you can start watching TV.
Figure 2
Figure 5
Figure 4
Figure 1
Figure 3
To Next Page
Loading...
Need help?
General