EasyManua.ls Logo

wingtra One - Page 41

wingtra One
59 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3.ConnecttelemetrylinktotabletandpowerWingtraOne.
AfterWingtraOneispoweredandtelemetryisconnectedtothetablet,WingtraPilotautomaticallytriesto
connect.Thispointinthechecklistisanautomatedtest.Connectthetelemetrytothetabletattheentry
righttothehomebutton.Connectmanuallyifyoudonotgetconnectedautomatically.
4.Checkbatteryvoltage
Thisisanautomatedtest.WingtraPilotcheckswhetherthebatteryvoltageisabove30V.Ifvoltageis
below30Vtake-offispreventedandyouhavetoswitchbatteries.
5.Checkeventakeoffposition
Thisisanautomatedtest.WingtraPilotcheckswhetherWingtraOneisstandingonevenground.Move
WingtraOneifthecheckisred.IfWingtraOneislevelandthecheckstaysred,repowerWingtraOne.
6.Turnontheremotecontrol
SwitchontheRContheOn/OffbuttoninthemiddleoftheRC.Afterswitchingiton,itautomatically
connectstoWingtraOneandyoucanseetheRCbatterychargeandthesignalstrenghtoftheconnection
onthetopleftoftheRCscreen.
Thischeckisnotyetautomated,confirmbyclickingthecheckpointinthechecklist.
7.CheckGPSsignals
Thisisanautomatedtest.Dependingonweather,itcanhappenthatyourWingtraOnedoesnotreceive
GPSlockforseveralminutes.IfGPSlockcannotbeestablishedaftermorethan5minutes,trytorepower
WingtraOne.Ifyoustillfailtoestablishconnection,openthebatterycoverandseeifthecabletotheGPS
moduleiswellconnected.Ifyoustillfailtogetreception,chatwiththeWingtraSupport.
8.Calibrateairspeed
Takethepitotcoveringoutofthepilotboxandcoverthepitottubewithit.Startairspeedcalibrationby
clickingonthecheckpointinthechecklist.Youwillreceivetheinstruction"Ensuresensorisnot
measuringwind".WaituntilyouheartheconfirmationofWingtraPilot:"Blowintopitottubewithout
touching".Then,removethepitotcoveringandblowstraightintothetube.
IfAirspeedcalibrationfails,youcanrestartitbyclickingontotherespectivecheckpointagain.Youhaveto
blowdirectlyintothetube.
InwindyweatherconditionstheAirspeedcalibrationcanfailfrequently.Toavoidfrequentretrialsshield
thepitottubewithyourhandfromwindbyformingacylinderaroundthetubewhenblowingintoitfrom
thetop.
9.PressReady-To-FlybuttononyourWingtraOne
YoumakeWingtraOnereadytoflybypressingtheReady-to-Flybuttonfor2seconds.Therewillbea
confirmationsoundandtheReady-to-Flybuttonwillstarttoblinkwithdoubleblinks(--------).By
makingWingtraOnereadytofly,youallowforsignalstothemotorsandflaps,andstartaroutinethat
checksthecamerabytakingsometestpictures.Thispointinthechecklistisanautomatedtest.
PreflightChecklist
41

Other manuals for wingtra One

Related product manuals