1. Turn off the unit and remove the front panel
by grasping the bottom outside edges
and pulling gently
toward you.
2. Pull out the Carbon Pre-filter and the
HEPA Filter by grasping the tabs
located on each side
of the filter.
4.
Place the HEPA and a new Carbon Pre-filter
in the unit. Only use original
filters designed for this unit.
3. Wash the HEPA filter with water only on
both sides as shown in image and leave
it to dry for 24 hours
or replace the
HEPA filter.
Washable HEPA Filter Cleaning
11
1/13/11
ϑ
www.sylvane.com 1-800-934-9194
To Next Page
Loading...
