Use AC 120V only.
Do not damage, break, forcefully bend, pull, twist, bundle, coat, pinch, or place heavy objects on the power
cord.
Periodically remove dust from the power plug. This will reduce the risk of shock due to humidity build up.
Remove the power plug from the outlet before cleaning the unit. When removing the power plug, grasp by
holding the plug itself, never hold by the cord.
If the power plug is damaged, it must be replaced by the manufacturer or a qualified technician.
Remove the power plug from the outlet when not in use.
Do not handle the power plug with wet hands.
Do not operate the unit when using indoor smoke generating insecticides.
Do not clean unit with benzene or paint thinner. Do not spray insecticides on the unit.
Do not use the unit where it is humid or where the unit may become wet, such as the bathroom.
Do not insert fingers or foreign objects into air intake or outlet.
Do not use the unit near flammable gases. Do not use near cigarettes, incense, or other spark-creating items.
Unit will not remove carbon monoxide emitted from heating appliances or other sources.
IMPORTANT PRECAUTIONS FOR USING YOUR AIR PURIFIER:
Do not block the intake or outlet vents.
Do not use near hot objects, such as a stove.
Do not use where the unit may come into contact with steam.
Do not use the unit on its side.
Keep away from products that generate oily residue, such as a deep fryer.
Do not use detergent to clean the unit.
Do not operate without a filter. ·
Do not wash and reuse the True HEPA Filter and Carbon Filter.
Hold the handle on the back of the unit to transport.
Do not hold by the front panel.
BATTERY IN REMOTE CONTROL:
· This product contains a button battery. If swallowed, it could cause severe injury or death in just two hours.
Seek medical attention immediately.
FREQUENTLY ASKED QUESTIONS
The unit does not turn on at all.
Is the plug securely attached to the outlet?
– Make sure the outlet has power going to it and ensure the plug is secured.
Is there a power outage?
– Check to see if other lights and electrical equipment are working and try again.
The unit doesn’t work in Auto Mode.
Has Auto Mode been selected?
– Press the Fan Speed button until Auto Mode is selected.
Is the sensor blocked or clogged?
– Wipe Odor Sensor with wet cloth, then dry.
It vibrates and makes a lot of noise.
Is it running on a slanted or uneven surface?
– Move the unit to a hard, flat, even area.
The power plug and outlet feel hot.
Is the plug securely plugged in?
– Make sure the plug is properly plugged into the outlet.
There is a strange smell.
Is it being used in a place with a lot of smoke, dust, or odors?
– Clean the air intakes on either side and clean the Pre-Filter.
– Replace the Activated Carbon Filter and
True HEPA Filter.
The fan strength is weak. The unit is not purifying the air.
Is the Check Filter Indicator light on?
To Next Page
Loading...
