Winix 6300-2 - Cleaning and Care Instructions; Cleaning the Filters; Exterior and Interior Cleaning

After replacing a filter, press the Filter Reset Button for at least 5 seconds.
CLEANING CARE
Cleaning the Filters:
Use a vacuum cleaner or soft brush to clean the Pre-Filter
If it is excessively soiled, rinse in room temperature water.
Do not use detergent or soap.
Allow the filter to dry for 24 hours or more before using.
Intervals between filter cleaning may vary depending on the air quality in the environment.
NOTICE
Do not use benzene, alcohol, or other volatile fluids, which may cause damage or discoloration.
Do not use hot water over 104oF.
Cleaning the Exterior & Interior:
1. Open the front panel and clean the interior with a vacuum cleaner.
• A handheld vacuum or hose attachment will work best.
2. Dampen a cloth with room temperature water and wipe down the interior and exterior of the unit.
3. Wipe the unit down with a clean, dry cloth.
Ensure no moisture remains before plugging the unit back in.
* For optimal performance, clean every 1 – 2 months.
NOTICE
When cleaning the unit, always unplug the power cord first and then wait until the unit has cooled down.
Never disassemble, repair, or modify this unit yourself.
Do not use flammable sprays or liquid detergents.
Do not allow children to clean or maintain the unit.
Before cleaning or maintaining, ensure unit is unplugged.
SAFETY AND CAUTIONS
Before operating this equipment, carefully read and follow these safety cautions.
Ensure filters are inserted before running unit. Running the unit without filters can shorten the lifespan of the unit
and cause electric shock or injury.