Winix AW600 - Troubleshooting

2827
▶ Power cord is plugged in.
▶ Low Water Indicator light
is on.
▶ Water is filled inside water
tank.
▶ Plug the power cord in.
▶ Fill the water tank.
▶ Make sure the water tank is
in place and filled correctly.
HumidiPür
TM
does
not turn on
▶ Power cord is plugged in.
▶ Auto Mode Indicator is on.
▶ Unplug power cord and
plug it back in.
▶ Push FUNCTION button to
select Auto Mode.
Auto Mode is not
working
▶ The unit is located on an
uneven surface.
▶ Move to an even surface.
Vibrates or makes
noise
▶ Power cord is plugged in.
Power cord is hot
▶ Unplug the power cord and
contact customer support.
TROUBLESHOOTING
Symptom Check If: Solution
▶ When evaluating the
performance of the Humidipür,
keep in mind that there are
various factors that influence
humidity level such as:
•Home insulation
•Layout
•Air circulation
•Water level of the CleanCel
󳟗
water tank
•Ceiling height and square
footage
▶ If the unit is utilizing the water
inside the CleanCel
󳟗
water tank
more than once daily, then the
unit is operating properly. Refill
water regularly for optimal
performance.
Note : In the case of extremely
dry environments, continuous
operation of the Humidipür unit
(up to 1 week) is recommended.
Humidity level reading is
not changing or does
not reach desired level.
▶ Child-Lock mode is on. ▶ Push Plasma/Child Lock
button for 3 seconds to
turn OFF Child-Lock mode.
Function button is
not working
▶ HumidiPür
TM
is being used
where strong odors and/or
dust is present
▶ Replace the water in the
water tank and change water
more frequently.
▶ Clean water tank and
CleanCel
󳟗
Antibacterial
Discs.
Unpleasant odors are
present
▶ Water is left inside the
water tank.
Low water level indicator
is on despite water being
in tank
▶ Refill the water tank.
Symptom Check If: Solution