Winix Tower XQ - Initial Operation; First Time Setup Steps

12
English Tower XQ
INITIAL OPERATION
①
Insert the power cord into an electrical
outlet.
②
Press the ‘Power’ button.
NOTE
ˍ
During the first 4 minutes of power up, the Air Quality
Indicator will flash as the Smart Sensors measure the air
quality in the environment, after which normal operation will
begin.
③
By default, when the unit first powers on, the
mode will be set to Auto with PlasmaWave
®
enabled.
ˍ
When in Auto mode, the fan speed will
be automatically adjusted according to
the environments air quality.
ˍ
PlasmaWave
®
works to remove harmful
airborne contaminants.
NOTE
ˍ
In Auto mode, as the indoor air quality improves, the fan
speed will automatically be reduced to Low.
ˍ
When the unit is running, you may hear a chirping or buzzing
sound. The sound is from large particles passing through
PlasmaWave
®
, it is normal and does not signify product
failure. To disable PlasmaWave
®
, see page 5.