9
English Tower XQ
INSTALLING / REPLACING FILTERS
④
Remove the new filters from protective
plastic wrap.
ˍ
Operating the unit without removing
filters from plastic wrap may cause
abnormal noise, deformation or fire as a
result of overheating.
⑤
Install the new filters until they fit securely
in place.
Filters must be installed in this order:
3 True HEPA filter (rear)
2 (CD) Carbon filter (middle)
1 Pre-filter (front)
ˍ
To install the Pre-filter, insert bottom tabs
into the slots on either side of the lower part
of the unit, then rotate upward to insert the
upper tabs into the slots at the top part of
the unit until sides audibly click into place.
⑥
Replace the front panel by first inserting
the latch at the bottom edge into the base
of the unit, then rotate the panel upward
toward the top of the unit until the magnets
pull the lid closed.
⑦
Resetting the Unit
ˍ
After replacing the filters, turn the power
onto the unit and then press and hold the
Filter Reset Button for 10 seconds.
To Next Page
Loading...
Need help?
General
