Winix ZERO 360 User Manual

5 - S TA G E A I R PUR IFIER
ZERO 360
6
CONTROL PANEL
02
05
13
03 03
01
06
07
04
09
08
14
10 11 12
15
01. Filter Life / Filter Reset Button
• A quick press will show the remaining filter
life:
indicated on the front display (F99 ~ F00).
• A long press of 5 seconds will reset the
filter life indicator.
- Use when replacing the filters.
- Filter Reset Button can be used when the
power is turned off.
- The filter life will be reset to 100%.
02. Light Mode Button
Use the light button to set the desired display
brightness. The display brightness cycles in
the order of 100%
70% 30% OFF. Other
features remain unchanged.
03. Fan Speed Adjustment Buttons
Adjusts the current fan speed.
• Use the Fan speed arrow buttons to set the
desired fan speed. Fan speeds cycle over
in this sequence: Auto, Low, Medium, High,
Turbo.
04. Auto Mode Button
The unit will default to Auto with
PlasmaWave
®
enabled when first powered on.
• Auto Mode automatically adjusts fan
speeds according to your indoor air quality.
The fan speed will adjust to low when air
quality is good, medium when fair, and to
high when poor.
05. Power Button
Turns the unit on or off. During the first
30seconds of power, the Air Quality Indicator
will cycle through Blue, Green, Amber and Red
colors.
• Smart Sensor takes approximately
4minutes to detect the air quality in the
environment before normal operation
begins.

Winix ZERO 360 Specifications

General

Brand	Winix
Model	ZERO 360
Category	Air Cleaner
Language	English