4-3
SECTION 4 –
APPLIANCES AND SYSTEMS
Normal vehicle leveling to provide comfort
for the occupants is satisfactory for refrigerator
operation.
Basic Operation
Switch on the Refrigerator
• Push and Hold the on/off switch for 1 second.
A light in the on/off switch will turn green.
• After 10 seconds the settings will dim. The
green light indicates the refrigerator is still
functioning.
• To check the settings push the on/off switch
again. The currently active settings will light
up.
Selecting a Source
• After switching on the refrigerator, push the
source button several times until the desired
source is selected.
NOTE: The 12V DC operation is only
operational while the engine is running.
Select Cooling Level
• Push the cooling button several times until the
desired level is selected.
• Set the refrigerator on cooling level 3, with an
ambient temperature between 60 and 75
degrees. A higher temperature needs a higher
cooling level, a lower temperature a lower
level.
NOTE: The refrigerator will retain temperature
more efficiently if food is cold before
placing inside.
Turn off the Refrigerator
• Push and Hold the on/off switch for 2 seconds
to switch off the refrigerator.
Further Information
Refer to the manufacturer’s user guide
provided in your InfoCase for complete operating
instructions, safety precautions, and maintenance
information.
REFRIGERATOR SERVICE
ACCESS COMPARTMENT
(Exterior) *Model 23A
The exterior refrigerator service compartment
allows access to the rear of the refrigerator for
inspection, maintenance, and service.
NOTICE
To prevent permanent damage to the
refrigerator cooling unit, turn the
refrigerator off if the vehicle will be parked
on an incline of over 3 side-to-side or 6
front-to-rear (such as steep driveways or
parking lots, etc.) for more than one hour.
Place bubble level in bottom of refrigerator
Bubble must be at least 1/2 inside circle
To Next Page
Loading...
