3-1
5 - DASH / AUTO
SECTION 3 – DRIVING YOUR MOTOR HOME
The information in this section refers only to
features installed or adapted to the dash and
driver compartment area by Winnebago
Industries
®
. It also includes passenger seating in
the living area of the coach.
Further Information
See the chassis manual in your InfoCase for
all original chassis related controls,
instrumentation, switches, and other features.
This includes items such as cruise control,
climate controls, gauges, wipers, lights, front
seats, and three-point safety belts, etc.
SEATS – DRIVER/CO-PILOT
(CHASSIS SUPPLIED)
-If Equipped
The driver and co-pilot seats may be
independently adjusted to suit individual
preference.
Further Information
See the chassis manual in your InfoCase for
instructions on seat adjustments.
SEATS – DRIVER/CO-PILOT
(FLEXSTEEL)
-If Equipped
The Driver and Co-pilot Seats may be
independently adjusted to suit individual
preference.
To move the seat forward or backward, lift the
slide release paddle (located on the outboard side
of the seat) and exert slight body pressure in the
direction desired.
The swivel/lift feature allows the seats to be
turned toward the living area for additional
seating while the unit is parked.
Pedestal Lift Operation
Raising the Seat
1. Assure the ignition key is in the “Accessory”
position and set the parking brake (refer to the
chassis operating manual provided in your
InfoCase).
2. Depress the Foot Pedal (located on the lower
back of the seat) and press and hold the
Activation switch (located on the back of the
seat) UP simultaneously until seat lift motion
stops.
3. Release Activation switch and Foot Pedal.
4. Remove key from ignition.
To Next Page
Loading...
Need help?
General
