Winnebago Via 25T User Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME
3-12
VALVE STEM ACCESS
(Mercedes-Benz
®
Sprinter Chassis)
Front Wheel Valve Stem Access on
18-Hole Steel Wheel with Push-On
Full Wheel Trim
–If Equipped
1. Obtain a double angle push/pull truck tire
gauge.
2. Locate the 6” hose extension (provided in
your InfoCase).
3. Push the end of the hose extension onto the
front wheel valve stem cap.
4. Using the hose extension as a remote handle,
unscrew the valve stem cap (retaining cap in
the end of the hose extension).
5. Adequate clearance is available to insert the
tire gauge onto valve stem.
6. When tire pressure testing is complete,
reinstall the valve stem cap (with the cap still
retained in the hose extension end).
7. Remove hose extension from valve stem cap.
Rear Inner Dual Valve Stem Access
on 18-Hole Steel Wheel with Push-
On Full Wheel Trim
–If Equipped
1. Obtain a double angle push/pull truck tire
gauge.
2. Locate the 6” hose extension (provided in
your InfoCase).
3. Push the end of the hose extension onto the
rear inner dual valve stem cap.

Winnebago Via 25T Specifications

General

Category	Motorhomes
Make	Winnebago
Model	Via 25T
Width	7'6"
Fuel Type	Diesel
Horsepower	188 hp
Torque	325 lb-ft
Transmission	5-speed automatic
Sleeping Capacity	4
GVWR	11, 030 lbs
Fresh Water Capacity	31 gallons
LP Gas Capacity	13 gal.
Engine	Mercedes-Benz 3.0L Turbo-Diesel