Winnebago Via 25T User Manual

SECTION 9 –
FURNITURE AND SOFTGOODS
9-6
3. Arrange dinette cushions to cover bed area.
Bed to Dinette
1. Reattach the table onto the wall support and
lower the table leg.
2. Make sure that the table leg is secured into the
floor support bracket and the leg brace is
locked.
DINETTE CONVERSION
–If Equipped
(Typical view – your coach may differ)
Dinette Table Setup
1. Remove dinette table and pedestal leg from
underneath the sofa.
2. Insert dinette pedestal leg into the metal
receiver on the floor.
Your coach may be equipped with two metal
receiver locations:
• One located in front the sofa.
• The other located behind the driver and
passenger cab seats.
NOTE: The cab seats must be completely rotated
(facing the lounge area) to use as dinette
seating. See the Driver/Co-Pilot Seat
information in Section 3 - Driving Your
Motorhome for complete operating
instructions.
Table
Bracket
Wall
Support

Winnebago Via 25T Specifications

General

Category	Motorhomes
Make	Winnebago
Model	Via 25T
Width	7'6"
Fuel Type	Diesel
Horsepower	188 hp
Torque	325 lb-ft
Transmission	5-speed automatic
Sleeping Capacity	4
GVWR	11, 030 lbs
Fresh Water Capacity	31 gallons
LP Gas Capacity	13 gal.
Engine	Mercedes-Benz 3.0L Turbo-Diesel