Winnebago Via 25T User Manual

9-3
SECTION 9 –
FURNITURE AND SOFTGOODS
2. Arrange the cushions to fill in the open spaces.
To convert bed back into stored position,
remove cushions and push bed board against
wall.
NOTE: Ensure the bed is in the stored position
(flush against driver side wall with
cushions removed) before retracting the
slideout room to prevent possible
property damage.
COMFORT SOFA SLEEPER
–If Equipped
(Typical view – your coach may vary
according to floorplan)
Your coach may be equipped with a Comfort
Sofa Sleeper, which is featured with an air bed
that can be adjusted to the firmness of your
choice.
Sofa to Bed
1. Remove seat back cushions and set aside.
2. Remove rectangular seat back cushion and set
aside.
3. Using the pull strap (attached to the back side
of the sofa), pull the sofa back out and extend
all the way down to the floor.

Winnebago Via 25T Specifications

General

Category	Motorhomes
Make	Winnebago
Model	Via 25T
Width	7'6"
Fuel Type	Diesel
Horsepower	188 hp
Torque	325 lb-ft
Transmission	5-speed automatic
Sleeping Capacity	4
GVWR	11, 030 lbs
Fresh Water Capacity	31 gallons
LP Gas Capacity	13 gal.
Engine	Mercedes-Benz 3.0L Turbo-Diesel