Connecting to your WiFi network
The following screen will appear. You can choose <Yes>
to proceed to search for the available WiFi network. If your
router has the WPS function, you can select <Yes(WPS)>
to proceed.
It will then start scanning the network. After the search is
done, it will display a list of the available Wifi networks.
Choose your network from the list, enter the WEP(Wired
Equivalent Privacy) or WPA(Wi-Fi Protected Access)
code. If your network is not enabled with security code,
the unit will connect to the network automatically.
Note: The encryption code would have been set up by
the person who set up and configured your network.
Please refer to the “Remote Control character list” for you
to enter the passwords. Press the “►” button to go to the
next entry, press “◄” button to make correction, press OK
when the last character is entered.
01:4 4
Linksys
Homeaudio
Demo
01:01
Would you like to
configure Network now?
Yes(WPS) NOYes
Ent er
Password
1/1
16:23
Input: Ç È Å Move Æ OK
- 07 -
To Next Page
Loading...