Getting started
Connect the mains adaptor to the radio unit, one end to
the DC IN on the radio and the other end to the mains wall
outlet.
Caution: Use only the mains adaptor supplied with the
radio. Connecting a power supply with a different
rating will cause permanent damage to the radio and
may be hazardous.
The radio is an adaptor and does not have internal
speaker. Prepare a powered speaker which has the
3.5mm pin in plug in to the 3.5mm line out jack on the
radio.
The radio supports also the optical connection. If you
have a system comes with optical input, connect to the
optical out on the radio to listen.
Switch the radio on using the Power on/off switch at the
rear side of the radio. The display on the front of the radio
will light up and show:
Then you can select your prefer language on the radio.
It will ask you if you want to Enable the <Check Network
when Power on>, it is suggested to choose <Yes>. Then
the radio will always check the available WiFi network
automatically.
• English
Deutsch
Español
Français
1/17
01:44
Welcome
- 06 -
To Next Page
Loading...