7
• Have your stove and chimney system installed by a certifi ed stove installer or licensed contractor.
• All installations must meet local codes.
• Use 4, 5 or 6 inch standard class A 103 HT exhaust chimney system.
• Use a minimum of 24 gauge, 4 inch or larger connector pipe.
• This is a wood stove that burns wood pellet fuel, this means natural draft is running the stove, it must
be treated as a wood stove with the pipe installation being as vertical as possible to obtain maximum
upward draft.
• Horizontal runs and elbows are discouraged.
• Do not install a fl ue damper in the exhaust vent.
DO NOT CONNECT THIS UNIT TO CHIMNEY FLU SERVING ANOTHER APPLIANCE.
Chimney connector must be in good condition and kept clean. Exhaust venting system termination
requirements, including location restrictions: relationships to air inlets, distance from windows, doors, air inlets,
and distance to combustible materials MUST BE MAINTAINED AT ALL TIMES.
For residential use Install only with a chimney complying with the requirements for class A 103 HT chimneys
in the standard for chimneys, Factory built, residential type and building heating appliance.
Stove is also Mobile home approved in the U.S. but not in Canada. Mobile home installation also requires
that a direct outside air kit be installed and the stove be bolted or fastened to the fl oor and a #10 copper
wire be attached to the stove and then attached to the frame of the manufactured home to ground the
stove. Only approved pellet vent can be used. No single wall connector pipe is allowed in a Mobile Home.
For mobile home use (US ONLY) Install with class A 103 HT chimney using 4, 5 or 6 inch diameter with ceiling
trim plate, attic insulation shield, fl ashing, storm collar and cap. 4, 5 or 6 inch dual wall connector pipe can
be used to chimney.
WARNING: DO NOT INSTALL IN A SLEEPING ROOM! CAUTIONS: STRUCTURAL INTEGRITY OF THE MOBILE HOME
FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED.
When this room heater is not properly installed, a house fi re may result. To reduce the risk of fi re, follow the
installation instructions. Contact local building or fi re offi cials about restrictions and installation inspection
requirements in your area.
For basement use, Install only with a chimney complying with the requirements for class A 103 HT chimneys
in the standard for chimneys, Factory built, residential type and building heating appliance, outside air source
must be supplied.
DO NOT CONNECT TO OR USE IN CONJUNCTION WITH ANY AIR DISTRIBUTION DUCT WORK UNLESS SPECIFICALLY
APPROVED FOR SUCH INSTALLATION.
Taler or longer chimney system’s may need a barometric damper installed immediately off the top of the
stove to be able to control the stove down in the 400° range as you can experience excessive draft and the
stove will want to run hotter.
STOVE PIPE INSTALL/ HELPFUL HINTS
To Next Page
Loading...