FCC PART 15
This device complies with part 15 of the FCC rules. operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Note: the grantee is not responsible for any changes or modifications not expressly approved by the party
responsible for compliance. such modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by Wisycom srl may void the FCC
authorization to operate this equipment.
Antennas are not provided with this device. This radio transmitter (FCC ID: POUMTK982) has been approved by
FCC to operate with the antenna having a maximum gain of 3 dBi. Antennas having a greater gain are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms.
The antenna(s) must be installed and operated at a minimum distance of 20cm between the radiator and your
body.
Wiscyom recommend to use the omnidirectional antenna ADN2 (with N
connector) or ADB2 (with BNC connector)
SPECIFICATIONS
• Gain: 3dBi typical
• Bandwidth: < 1:1.5 in the range 430 ÷ 960 MHz
< 1:1.9 in the range 430 ÷ 1160 MHz
• Polarization: vertical
To Next Page
Loading...
