VERSION. 1.1.18
STEP 1. STEP 2. STEP 3.
STEP 4.
STEP 5.
HOPPER CLEANING
Unlock hoppers with multitool by
turning in clockwise direction
WMF 1200S - CLEANING INFORMATION
Thoroughly wipe out hopper
using a damp cloth.
Thoroughly clean individual
dosing auger components.
THIS CLEANING PROCEDURE
TAKES APPROX. 15 MINUTES
PERFORM THIS AT THE END
OF THE MONTH.
ENSURE HOPPERS ARE
DRY BEFORE RE-FITTING
Please note, once you have dried the hopper after washing, it is important that
the hopper is reassembled correctly for proper functioning. Please use the
exploded diagram as a guide for reassembly and make sure that the half moon
opening is at the top before re-inserting the hopper.
IMPORTANT: HOPPER REASSEMBLY
open
close
Press the ON/OFF switch for
longer than 2 seconds until
coffee machine switches off.
Disconnect mains plug.
Lift hopper out and empty.
Unscrew union nut at
front & rear and remove the
dosing auger.
Never clean hoppers
in the dishwasher.
Allow hopper and individual
components to dry completely
before reassembling
To Next Page
Loading...
