WMF 9192 - Directives; Duties of the Owner;Operator

50
User Manual WMF Cooler
Safety
6.3 Directives
The machine fulfils the requirements of the
Regulation on Commodities (andcounter-
parts in the European Plastics Directives)
and the EC regulation No.1935 / 2004 in
the currently valid edition.
When used properly, the machine does
not present ahazard to health or other
unjustifiable hazard.
The materials and products used comply
with the Regulation on Commodities
(andcounterparts in the European Plastics
Directive 2002 / 72 / EG ff.)
The machine fulfils the requirements of
all applicable regulations in the directives
MD (MR) 2006 / 42 / EC (EG), EMCD (EMV)
2004 / 108 / EC (EG), Directive 2002 / 95 / EC
(ROHS), Directive 2002 / 96 / EC (WEEE).
The declaration of conformity is included
with the machine. The machine bears
the CE mark. Any modifications that are
not approved by WMF will cause this
declaration to become invalid.
Currently valid national rules apply in
countries outside of the European Union.
This device is subject to the directive on
waste electrical and electronic equipment
(WEEE / EU directive) and may not be
disposed of as domestic waste.
For disposal please contact the
WMFService.
6.4 Duties of the owner /
operator
The operator of such equipment
must ensure regular maintenance by
WMFService technicians, their agents or
other authorised persons, and checking of
safety devices.
Access to the service area is permitted only
for persons with knowledge and practical
experience with the unit, especially
regarding safety and hygiene.
The coffee machine must be set up by the
operator such that care and maintenance
can be performed without hindrance.
In office / floor supply or similar self-service
applications, only staff instructed in
operation of the machine should supervise
the machine. Trained personnel should
carry out maintenance and be available for
questions regarding use.
The operator shall ensure that electrical
equipment and operating facilities are
in afit state (e.g. to BGVA3) [German
Accident Prevention Association or
equivalent]. In order to ensure operational
safety of your device regular inspection
is necessary. These measures are
conducted by the WMFService or by WMF
authorised service personnel as part of the
maintenance work.
The manufacturer‘s specifications regarding
maintenance cycles and frequency of
maintenance are to be observed.