joystick and make sure it’s in lock position
3、If hydraulic oil’s temperature is low, the responsiveness of
working device joystick will be slow, so please warm up the machine
before work.
4.Please following below procedures before dismounting hydraulic
attachments：
⑴Lower engine rotate speed, lay down the bucket on the ground ;
⑵Shut down the engine, move both sides working device joysticks
to all directions;
⑶Wait at least 10 minutes to release pressure in hydraulic circuit.
Do not ignore any above procedure to avoid dangerous.
6、Do not come close to the machine before working device touch
the ground.
1、Boom operation
Please avoid bucket tooth hooking on dozer blade when boom
going down.
2、Arm operation
When stretch out the arm, if the arm is vertical to the ground there
might be momentary movement pause, this is not malfunction
please do not worry about that.
3 、Fast swing or deflection will short machine service life, please
don’t operate like that.
●Swing/boom deflection switch joystick
It is for switching between upper platform swing and boom
deflection.
Push down the switch joystick to position, if you move left ope
ration joystick the boom should deflect to left or right。Pull up
the joystick and the machine is in swing model, if you move
left operation joystick the upper platform will swing.
To Next Page
Loading...
