Gas Range Installation 17
wolfappliance.com/specs
Verify Range Operation
SURFACE BURNERS
IMPORTANT NOTE:
Prior to operating the range, be sure
to read the entire Wolf gas ranges use & care guide
included with the range for important safety, service and
warranty information.
The surface burners use electronic igniters in place of
standing pilots. When the burner control knob is pushed in
and turned to the HIGH position, the system creates a
spark to light the burner. This sparking continues until the
electronic ignition senses a flame.
Be sure to place the burner parts on each burner base and
install the burner grates before lighting.
To check operation of the surface burners, push in and
turn each control knob to the HIGH position. The flame
should light within four seconds.
IMPORTANT NOTE: Initial lighting of the surface burners
may take slightly longer, as air in the system must be
purged before gas can be supplied to the burner.
If the burners do not light properly, turn the control knob
to the OFF position. Check that the burner parts are in the
proper position. Check that the power cord is plugged in
and that the circuit breaker or house fuse has not blown.
Check that the shut-off valve is in the ON position. Check
operation again, waiting at least five minutes; if the
burners do not light properly, contact a Wolf authorized
service center.
OVEN OPERATION
Turn the oven(s) on and verify that they are coming up to
temperature.
IMPORTANT NOTE: A small amount of smoke and odor
may be noticed during the initial break-in period. Refer to
the use & care guide for additional information.
To Next Page
Loading...
