Component Access and Removal
GGAASS CCOOOOKKTTOOPP--
GGAASS CCOOOOKKTTOOPP--
22
22
SSEERRIIEESS
SSEERRIIEESS
4-2
COMPONENT ACCESS AND REMOVAL
This section explains how to access and remove components from a Wolf Gas Cooktop. Depending on which com-
ponent you are going to access or remove in the following sections, you may have to remove other components first.
Refer to appropriate section in this manual that explains how to access and remove those various components.
When reassembling, just reverse steps that were used to access and remove the components.
NOTE: Access to the manifold, valves, connections and wiring can be gained through access covers on the burner
box. Although space is limited, it will help in some diagnosis and repairs.
NOTE: Before attempting to access or remove any components from a Wolf Appliance, take note of the following
warnings.
TO AVOID SERIOUS BURNS AND/OR EXPLOSIONS, KEEP COMBUSTIBLES AWAY FROM APPLIANCE
WHENEVER A FLAME IS PRESENT. SURFACES AND COMPONENTS GET HOT DURING THE USE OF THE
APPLIANCE.
TO AVOID ELECTRICAL SHOCK, POWER TO UNIT MUST BE DISCONNECTED WHENEVER ACCESSING
AND/OR REMOVING COMPONENTS POWERED BY ELECTRICITY OR COMPONENTS NEAR OTHER ELEC-
TRICAL COMPONENTS.
TO AVOID POSSIBLE GAS LEAKS AND/OR EXPLOSIONS, GAS TO UNIT MUST BE SWITCHED OFF AT SUP-
PLY SOURCE WHENEVER ACCESSING AND/OR REMOVING COMPONENTS.
TO ENSURE PROPER BURNER OPERATION, THE O-RINGS MUST BE REPLACED ANY TIME THE UNITS IS
DISASSEMBLED FOR ANY REASON.
WHEN REASSEMBLING GAS SUPPLY LINE TO REGULATOR, ONLY PIPE THREAD COMPOUND SHOULD
BE USED. DO NOT USE TEFLON TAPE TO SEAL GAS PIPE CONNECTIONS.
WHEN REASSEMBLING REGULATOR TO MANIFOLD, ONLY PIPE THREAD COMPOUND SHOULD BE
USED. DO NOT
USE TEFLON TAPE TO SEAL GAS CONNECTIONS.
To Next Page
Loading...
