Wolf ICBSRT364G - Safety Precautions; Important Instructions; Specifications; Installation Requirements

wolfappliance.com | 3
Installation Requirements
WARNING
Prior to installation, ensure the local distribution
conditions (nature of the gas and gas pressure) and
the adjustment of the appliance are compatible.
The adjustment conditions for this appliance are
stated on the label or data plate. This appliance is
not connected to a combustion products evacuation
device. It shall be installed and connected in accor-
dance with current installation regulations. Particular
attention shall be given to the relevant requirements
regarding ventilation. Refer to the dimensions
provided in this guide, if ventilation installation
specifications dier.
SpecificationsSafety Precautions
IMPORTANT INSTRUCTIONS
• These instructions are only valid if the country symbol
appears on the appliance. If the symbol does not appear on
the appliance, it is necessary to refer to the technical instruc-
tions which will provide the necessary instructions concern-
ing modification of the appliance to the conditions of use of
the country.
• The power supply cord must be obtained from an authorized
Wolf dealer and installed by Factory Certified Service.
IMPORTANT NOTE: When installing against a combustible
surface, a minimum 127mm riser is required for model
ICBSRT366, and a minimum 254mm riser is required
for 914mm and 1219mm sealed burner rangetops with
a chargrill or griddle/teppanyaki. Follow all minimum
clearances to combustible surfaces shown in the
installation illustration on the following page. Models
ICBSRT362W and ICBSRT484W cannot be installed against
a combustible surface.