wolfappliance.com | 7
Troubleshooting
Troubleshooting
IMPORTANT NOTE: If the rangetop does not operate
properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the rangetop.
• Verify the gas supply shut-o valve is in the open
position.
• If the rangetop does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
rangetop. Wolf is not responsible for service required to
correct a faulty installation.
Gas Supply Connection
All connections to the gas piping must be wrench-tight-
ened. Do not overtighten or allow pipes to turn when
tightening.
If a flexible metal connector is used, verify it is not kinked,
then attach the gas supply line to the regulator on the
rangetop. Open the valve and check for leaks by placing
a liquid detergent solution onto all gas connections.
Bubbles around the connections indicate a gas leak. If a
leak appears, close the shut-o valve and adjust the
connections.
Installation Checklist
Verify operation after installation:
• All packaging material has been removed.
• All specified clearances have been maintained.
• Each burner ignites individually.
• All flames appear normal.
• The unit has been tested for gas leaks.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Installation
To Next Page
Loading...
