Component Removal
Induction Range (IR) Series
Induction Range (IR) Series
3-9
#827176 - Revision A.1 - December, 2016
Induction Range
The induction range has a Induction Cooktop attached
to a Dual Fuel oven. To access the majority of the com-
ponents the unit needs to be pulled from the installa-
tion, and the induction cooktop needs to be removed.
Induction Cooktop Removal
To remove the induction cooktop top, first remove the
unit from the installation, then (See Figure 3-19):
Extract the six screws from the back of the island1
trim.
Remove the island trim.2
Extract the two outer screws from the rear of the3
cooktop.
Lift the cooktop from the rear, disengaging the front4
of the cooktop from the keyhole slots on the bull-
nose.
Disconnect the induction cooktop electrical connec-5
tion.
Remove the cooktop.6
Bullnose Removal
To remove the bullnose, first remove the cooktop, then
(See Figure 3-20):
Open the oven door and extract the two screws on1
each side of the unit below the bullnose.
Lift the bullnose straight up, disengaging it from the2
four shoulder screws.
Disconnect the Control to ECH harness from the3
ECH.
Remove the bullnose.4
Figure 3-19. Induction Cooktop Removal
Figure 3-20. Bullnose Removal
To Next Page
Loading...
