Need help?Do you have a question about the Wood-mizer HR120 and is the answer not in the manual?
General| Brand | Wood-mizer |
|---|---|
| Model | HR120 |
| Category | Saw |
| Language | English |
Explains safety symbols and signal words used for personal safety.
Provides instructions for safe operation, including warnings and cautions.
Information on obtaining service, including contact details and office hours.
Detailed technical specifications for the resaw machine models.
How to identify the machine using model, serial, and revision numbers.
Instructions for initial setup and placement of the resaw machine.
Guide for electrical installation, including safety and technical requirements.
Procedure for adjusting the upper hold-down roller assembly for secure material handling.
Steps to adjust the outer blade guide arm for optimal material positioning.
How to tilt the conveyor table for cutting tapered lap siding.
Instructions for installing the optional shingle belt assembly.
Guide on how to properly tension the bandsaw blade for optimal performance.
Step-by-step instructions for safely replacing the bandsaw blade.
Procedure for ensuring the blade tracks correctly on the blade wheels.
Information on setting up optional conveyor tables for material handling.
How to operate the saw head's up and down movement.
Procedures for starting the resaw machine (gas, diesel, electric).
How to engage and disengage the blade clutch/brake lever.
Instructions for operating the feed system and adjusting feed rate.
How to use the water lube system to keep the blade clean.
Instructions for operating the optional shingle belt system.
Maintenance checks for blade guide rollers.
Procedures for removing sawdust from critical machine areas.
Maintenance and lubrication of vertical mast rails.
Checking and replacing blade wheel belts.
How to adjust the drive belt tension for proper operation.
Safety and procedures for charging the machine's battery.
Maintenance of the feed system, including conveyor belt.
Overall procedure for aligning the resaw machine for accurate cuts.
Steps for installing a blade as part of the alignment process.
How to align the blade wheels for proper blade tracking.
Instructions for installing the blade guide assemblies.
Procedure for aligning the blade guide arm parallel to the blade.
How to set proper blade deflection using the blade guides.
Adjusting the vertical tilt of the blade guides for optimal performance.
Adjusting the horizontal tilt of the blade guides.
Setting the correct distance between the blade guide roller flange and the blade.
Calibrating the blade height scale for accurate measurement.
Steps to align and tighten the conveyor belt if it slips.
To Next Page