Why do Wood-Mizer Saw blades break prematurely?
Premature blade breakage in your Wood-Mizer Saw can occur due to several reasons. Check the rubber belts on the blade wheels for wear, indicated by shiny spots, and replace them if needed (B-57). Ensure the blade tension is set to the recommended specifications. Also, poor sharpening techniques can cause blade breakage.
How to prevent Wood-Mizer Saw blades from dulling quickly?
To prevent Wood-Mizer Saw blades from dulling quickly, ensure that you clean or debark logs, especially on the entry side of the cut. When grinding teeth, grind just enough metal to restore sharpness, avoiding excessive heating by using water/coolant. Also, poor sharpening techniques can cause blades to dull quickly.
General| Brand | Wood-mizer |
|---|---|
| Model | LT10 |
| Category | Saw |
| Language | English |
Explains the meaning of various safety symbols used in the manual.
Safety precautions for blade installation and removal.
Safety guidelines for mill placement and setup.
General safety rules and warnings for operating the sawmill.
Safety instructions to follow when performing maintenance tasks.
Safety guidelines for electrical and mechanical maintenance.
Initial setup procedures for the sawmill, including leveling and power.
Step-by-step guide for changing the saw blade.
Procedure for properly tensioning the saw blade.
How to align the blade on the drive and idle wheels.
Instructions for safely starting the sawmill motor.
Procedures for handling, positioning, and securing logs.
How to control the movement of the saw head during cutting.
Detailed steps for performing normal log cutting operations.
Common issues encountered during sawing and their solutions.
Procedures for installing and aligning the saw blade.
Ensuring the vertical and horizontal levelness of the blade wheels.
Adjusting the blade guide arm for proper blade tracking.
Positioning the blade guides for optimal cutting performance.
Adjusting the blade guides to achieve correct blade deflection.
Adjusting the vertical angle of the blade guides.
Setting the correct distance for blade guide flanges.
To Next Page
