Setup & Operation
Blade Drive Operation
3
3-18 doc082114 Setup & Operation
See Figure 3-17.
3.10 Blade Drive Operation
IMPORTANT! When starting the machine for the first time, check that
main motor rotation direction is as indicated by the arrow located on
the motor body (fan guard). If the rotation direction is incorrect, invert
the phases in the phase inverter located in the power socket (electric
box). Correct motor rotation direction is indicated by the arrow located
on the motor body.
DANGER! Make sure all guards and covers are in place and
secured/closed before operating the sawmill. Failure to do so may
result in serious injury.
WARNING! Always wear eye, ear, respiration and foot protection when
operating the sawmill. Failure to do so may result in serious injury.
Be sure the blade housing cover is in place and secured before starting the engine or motor. Use the
rubber latches to fasten the blade housing cover shut. If the blade housing cover is not closed and
secured, the safety switch located on it interrupts the ignition circuit and the motor/engine cannot be
started. If the cover is opened during the mill operation, the engine/motor will be stopped.
To engage the blade, perform the following steps:
1. Clear any loose objects from the area of the blade, motor, and drive belt.
2. Make sure the clamps and side supports are positioned low enough for the blade to pass over them.
Make sure the log is clamped securely.
FIG. 3-17
Move the handle right
to move the blade arm out.
Move it left to move
the blade guide in.
To Next Page
Loading...
