To Next PageTo Next PageWhy do up/down or power feed motors overheat on Wood-mizer LT30HD Super Remote Saw?
If the up/down or power feed motors on your Wood-Mizer Saw overheat and lose power, allow the motor to cool before restarting, as normal operation factors may have been exceeded.
What to do if nothing works electrically on Wood-Mizer Saw?
If nothing works electrically on your Wood-Mizer Saw, check for a short circuit or turn OFF the key if the battery is dead. Replace the circuit breaker if it is bad. Replace the fuse if it is bad. Check the connections if there is a bad connection in the battery. Remove the connection and clean the posts if there is corrosion on the battery post.
What to do if drive belts come off pulleys when disengaging blade on Wood-mizer Saw?
If the drive belts come off the pulleys when disengaging the blade on your Wood-mizer Saw, adjust the brake strap if it is too loose. Realign the brake drum on the drive shaft if it is misaligned. Also, adjust the brake strap if it's tightened unevenly.
Why does height adjustment jump on Wood-mizer LT30HD Super Remote?
If the height adjustment on your Wood-mizer Saw jumps or stutters, lubricate the mast track surface. Adjust the up/down chain, adjust the vertical wear pads if they are too tight and adjust belts if drive belt(s) loose.
How to stop sawdust buildup on track of Wood-mizer LT30HD Super Remote?
If sawdust builds up on the track of your Wood-mizer Saw, avoid excessive oiling. Adjust the wipers to firmly contact the track if they are worn. Clean the track with solvent and apply silicone spray if the track is sticky.
Why are boards thick or thin on ends or middle when using Wood-mizer LT30HD Super Remote?
If boards cut by your Wood-mizer Saw are thick or thin on the ends or middle, take equal cuts off opposing sides after the log has been squared. Remove a board, repeat, keeping the heart in the middle of the cant, making it your last cut. Resharpen and reset the blade if there's a set in the teeth. Realign the sawmill if the bed rails are misaligned.
What to do if up/down or power feed motors do not work on Wood-Mizer Saw?
If the up/down or power feed motors on your Wood-Mizer Saw do not work, replace the drum switch or remove the control panel cover and clean the contacts if the contacts in the drum switch are worn. Replace the motor if it is burned out. Check for loose wire or terminal connections on the battery.
What causes the lumber from Wood-mizer LT30HD Super Remote to not be square?
If the lumber from your Wood-mizer Saw is not square, adjust the side supports to be square to the bed. Ensure the blade is parallel to the bed rails, remove any sawdust or bark between the cant and bed rails, and resharpen and reset the blade to address tooth set problems.
What causes the Wood-mizer LT30HD Super Remote battery to not stay charged?
If the Wood-Mizer Saw battery will not stay charged, ensure the key switch is OFF when not in use. Check for shorts in the system and have the charging system checked by an authorized Onan dealer. Also, check fluid levels in the cells and add proper solution, adjust the low end RPM, and check for loose wires on the alternator light, replacing it if necessary.
Why do Wood-mizer LT30HD Super Remote blades break prematurely?
If Wood-mizer Saw blades break prematurely, replace worn blade wheel belts (B-57) if they are contacting the metal pulley. Ensure proper sharpening techniques are used (refer to the Sharpener Manual). Also, ensure the blade tension is set to the recommended specifications.
General| Brand | Wood-mizer |
|---|---|
| Model | LT30HD Super Remote |
| Category | Saw |
| Language | English |
