Need help?Do you have a question about the Wood-mizer LT70HD and is the answer not in the manual?
General| Blade Speed | Variable |
|---|---|
| Power Options | Diesel |
| Blade Length | 158 inches (401 cm) |
| Max Log Diameter | 36 inches |
| Max Log Length | 21' 4" (6.5 m) |
| Weight | 5, 500 lbs |
| Blade Width | 1.5 inches |
| Fuel Type | Diesel |
| Blade Thickness | 0.045 inches |
General overview of the manual's purpose and scope.
Information on how to obtain customer service and support.
Technical details and dimensions of the sawmill model.
Details on identifying the sawmill and owner information.
Terms and conditions of the product warranty.
Explanation of safety symbols and signal words used in the manual.
Crucial safety guidelines and warnings for operation and maintenance.
Procedures for safely de-energizing equipment before service.
Steps for setting up the sawmill in a fixed location.
Instructions for setting up the sawmill when using a trailer.
Procedure for safely changing the sawmill blade.
How to properly tension the bandsaw blade for optimal performance.
Method for ensuring the blade runs correctly on the wheel.
Steps for starting the sawmill's engine or motor.
Operation and safety for the automatic board return system.
Instructions for installing and aligning the debarker accessory.
Overview of the Distributed Control System (DCS) hydraulic controls.
Procedures for safely loading, turning, and clamping logs.
How to operate the up/down system using DCS controls.
Using the DCS to adjust the blade guide arms.
Engaging and disengaging the blade using the autoclutch system.
Operating the carriage movement and feed rate controls.
Navigating and configuring the DCS control panel settings.
Using automatic modes for blade height adjustments.
Step-by-step guide for cutting logs with the sawmill.
Process for edging boards to achieve desired dimensions.
Alternative methods for maximizing production rates during cutting.
Understanding and using the blade height measurement scales.
How to operate and maintain the water lube system for blade cleaning.
Steps to secure the sawmill for safe transport.
Estimated lifespan of common replacement parts.
Inspection, adjustment, and maintenance of blade guide assemblies.
Procedures for cleaning sawdust from various parts of the sawmill.
Maintenance for the carriage track, wipers, and scrapers.
Cleaning and maintenance of the vertical mast rails.
Routine maintenance for chains, pivots, and decals.
How to add fluid and maintain the blade tensioner assembly.
Checking and replacing blade wheel belts.
Procedures for adjusting and maintaining drive belt tension.
How to adjust and check the brake pads.
Tightening and inspecting the autoclutch belt.
Checking hydraulic fluid, filters, and pump motor brushes.
Adjusting chain tension and maintaining the up/down motor and gearbox.
Adjusting the power feed chain and checking gearbox oil.
Safety precautions and steps for charging the sawmill battery.
Procedure for replacing the festoon assembly.
Summary of maintenance tasks and their intervals.
Common sawing issues and their solutions.
Troubleshooting common hydraulic system issues.
Procedure for checking and adjusting hydraulic system pressure.
Steps to align engine, motor, and drive pulleys.
List of DCS error codes and their possible causes/solutions.
Steps for basic alignment of sawmill components.
Comprehensive procedure for full sawmill alignment.
Diagrams illustrating the sawmill's hydraulic system layout.
Visual representation of the hydraulic system's component connections.
List of hydraulic components with part numbers and descriptions.
Table detailing hydraulic hoses, their lengths, and applications.
To Next Page