Wood-mizer LT70HD - Saw Head Tilt

Sawmill Alignment
Saw Head Tilt
7
7-42 60HD-Rdoc072619 Sawmill Alignment
See Figure 7-47. Loosen the clamp stop bolts and adjust the clamp stop until it touches
the string. Loosen the jam nut and adjust the bolt on the middle-rear bed rail until it
touches the string.
Saw Head Tilt
As the blade enters a wide log or cant, the outside of the saw head will drop down slightly.
To compensate for the drop, the saw head is adjusted 1/16" (1.5 mm) higher at the out-
side.
FIG. 7-47
SM0191B
String across
side supports
Adjust clamp
stop to string
Adjust stop
bolt against string