Wood-mizer LT70 Super Hydraulic - Blade Guide Level

Sawmill Alignment
Blade Guide Level
Sawmill Alignment HD-R10doc072619 7-35
7
Retighten the screws and jam nuts. Adjust the stop bolt against the blade guide assembly.
2. Measure the distance between the flange on the inner blade guide roller to the back edge
of the blade. This distance should measure 1/16" (1.5 mm). Adjust the roller back or for-
ward if necessary.
Blade Guide Level
Perform the following adjustments to make sure the blade guide assembly is parallel to
the blade.
1. Loosen the alignment bar mounting bolt. Use the provided bottom block adjustment tool
to adjust the alignment bar up so the bar is close to, but not touching the bottom of the
blade. Retighten the alignment bar mounting bolt
2. Check that the gap from the alignment bar to the blade is the same along entire length of
the bar. Shine a flashlight behind the blade guide assembly to help you see the gap
between the bar and the blade.
3. Rev. B4.11+: Turn the tilt adjustment jam nuts to pivot the block assembly until the align-
ment bar is parallel to the blade. Retighten the jam nuts. Repeat for the second blade
guide assembly.
FIG. 7-38
1/16” (Inner Blade Guide)
1/8” (Outer Blade Guide)
Loosen top and
one side adjustment
screw
600214-1
Stop Bolt