What to do if my Woodward easYgen-1700 Controller goes into emergency stop?
If the Woodward Controller experiences an emergency stop, check if the emergency stop button works properly. Also, check whether the starting battery's positive pole is connected to the emergency stop input and whether the circuit is open.
How to fix abnormal RS485 communication on Woodward Controller?
If the Woodward Controller's RS485 communication is abnormal, check the connections and ensure the COM port setting is correct. Verify that the RS-485 connections of A and B are not reverse connected. Check if the RS485 transfer model or the communication port of the computer is damaged.
Why does my Woodward easYgen-1700 Controller fail to start?
If the Woodward Controller fails to start, check the fuel oil circuit and its connections. Also, inspect the starting batteries and the speed sensor and its connections. Refer to the engine manual.
What to do if my Woodward Controller causes a genset shutdown?
If the Woodward Controller experiences a genset shutdown, verify that the water or cylinder temperature isn't exceeding the specified limits. Also, check the genset AC voltage and the DC fuse.
How to troubleshoot Woodward easYgen-1700 Controller with no power?
If the Woodward Controller has no power, begin by inspecting the starting batteries. Then, check the controller connection wiring and the DC fuse.
What to do if high water temp alarm appears after crank disconnect on Woodward Control Unit?
If your Woodward Control Unit shows a high water temperature alarm after crank disconnect, check the temperature sensor and its connections.
What causes low oil pressure alarm after crank disconnect on Woodward Control Unit?
If your Woodward Control Unit shows a low oil pressure alarm after crank disconnect, check the oil pressure sensor and its connections.
What to do for ECU warning or shutdown on Woodward Control Unit?
If your Woodward Control Unit displays an ECU warning or shutdown, get information from the LCD of the alarm page. If there is a detailed alarm, check the respective engine. If there is no detailed alarm, please refer to the relevant section of the engine manual as specified in the SPN alarm code.
Why is Woodward Control Unit genset running but ATS not transferring?
If the genset is running but the ATS is not transferring in your Woodward Control Unit, check the ATS and the connections between the ATS and controllers.
How to troubleshoot ECU communication failure in Woodward Control Unit?
If the ECU communication failed on your Woodward Control Unit, check the CAN connections for high and low polarity, verify if the 120 ? resistor is connected properly, and check if the type of engine is correct.
General| Type | Generator Controller |
|---|---|
| Frequency | 50/60 Hz |
| Digital Inputs | 8 |
| Digital Outputs | 6 |
| Analog Outputs | 2 |
| Display | Graphic LCD |
| Relay Outputs | 6 |
| Operating Temperature | -20 to +70 °C |
| Communication Ports | RS-485 |
| Protection | Over/Under Voltage, Over/Under Frequency, Over Current, Short Circuit, Reverse Power |
| Protection Class | IP20 |
To Next Page
