To Next PageTo Next Page
Need help?Do you have a question about the Worcester Benchmark Danesmoor Utility 12/14 and is the answer not in the manual?
Detailed technical specifications for each model, including power, flow, resistance, and ratings.
Details required air inlet free area for open flue models.
Specifies minimum air vent free area for RS models installed in compartments.
Guidance on safe and appropriate locations for flue terminals.
Table detailing minimum distances for flue terminals based on position relative to openings and boundaries.
Specifications for oil tank installation and prohibition of certain pipework materials/joints.
Details on mains supply requirements, wiring compliance, and fuse ratings.
Procedures for removing and installing the burner, flue system, and heating system.
Detailed steps for connecting the oil supply pipe to the burner.
Steps to prepare the system, check the burner, and verify the installation before commissioning.
Procedures for bleeding the burner and priming the oil supply system.
Adjusting air shutter and pump pressure settings for optimal performance.
Guide to identifying lockout causes and the procedure to reset the appliance.
Troubleshooting steps for ignition failures, including checks for oil, electrodes, and the control box.
Diagnosing issues when the burner fails to start or operates incorrectly.
General