Do you have a question about the Worcester DANESMOOR and is the answer not in the manual?
Fuel Type | Oil |
---|---|
Installation Type | Floor Standing |
Fuel | Oil |
Model | DANESMOOR |
Dimensions | 600mm |
Covers air supply requirements for conventional and low-level flue models.
Covers air supply requirements for room sealed balanced flue models.
Details specifications and installation for conventional flues.
Information on converting to low-level discharge flue arrangements.
Installation of room sealed balanced flue systems.
Guidelines for positioning flue terminals to ensure safe dispersal.
Details on single pipe, double pipe, and de-aerator systems.
Guidelines for selecting pipe diameter and fitting components.
Details on copper and plastic pipework for sealed and open vent systems.
Compliance requirements for sealed primary systems.
Instructions for connecting the 230V AC mains supply to the appliance.
Information on fitting and connecting internal or external programmers.
Specific installation steps for conventional flue models.
Specific installation steps for room sealed balanced flue models.
Procedure for plumbing the boiler and filling the heating system.
Steps for connecting the oil supply pipe and hoses.
Steps for flushing, filling, and setting pressure for the heating system.
Inspection of burner components and settings before re-assembly.
Final checks on wiring, insulation, baffles, and connections.
Procedures for bleeding air from single pipe and double pipe systems.
Steps for initial checks before commencing servicing.
Detailed procedure for cleaning the fan impeller and burner components.
Troubleshooting steps for when the burner fails to ignite.
Diagnosing why the boiler does not respond to a call for heat.
Identifying causes for noisy operation, boiling, or intermittent flame.
Troubleshooting excessive smoke production during operation.
Addressing oil smells in the boiler room or from oil leaks.
Steps to resolve pulsation issues during burner start-up.