OPERATION (continued)
12
1. Locate Blowing Port of your Vac.
2. Insert the locking end of the
Dual-Flex™ Locking Hose into the
Blowing Port of the Vac. The Hose
should snap into place. To remove the
Hose from the Vac, press the Release
Button in the Hose Assembly and pull
the Hose out of the Vac Inlet.
3. (Optional) Attach Extension Wand to
opposite end of Hose, then place the
Car Nozzle on the Wand.
4. Turn Vac on and you are ready to use
your Vac as a Blower.
Car Nozzle
(Optional)
Dual-Flex
Locking
Hose
Blowing
Port
Extension
Wand
(Optional)
Swivel End
of Hose
Blowing Feature
Your Vac features a Blowing Port.
It can blow sawdust and other debris.
Follow the proceeding steps to use your
Vac as a Blower.
1. The Vac comes equipped with a Drain
for easy emptying of liquids. Simply
unscrew the Drain Cap and lift the
opposite side slightly to empty the
Drum.
2. Another option is to remove the
Powerhead Assembly.
3. Lay Powerhead Assembly aside on a
clean area while emptying Drum.
4. Dump the Drum contents into the
proper waste disposal container.
WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
Emptying the Drum
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
C
AUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended hours or when using in a
noisy area.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
!
!
!
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
!
WARNING: To reduce the risk of
electric shock or fire, unplug Vac
when not in use. Never leave
running while unattended.
!
SP6852-2 Workshop 14 Gallon.qxp_WS1400CA0 8/27/18 3:37 PM Page 12
To Next Page
Loading...
Need help?
General
