EasyManuals Logo

Workshop WS1400CA User Manual

Workshop WS1400CA
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
MAINTENANCE
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning Filter.
Filter
NOTE: The Filter is made of high quality
paper designed to stop very small
particles of dust. The Filter can be used
for dry pick up or small amounts of liquid.
Handle the Filter carefully when removing
to clean or installing it. Creases in the
Filter pleats may occur from installation
but will not affect the performance of the
Filter.
Removal and Installation
of the Qwik Lock™ Filter
Filter Removal:
1. Hold the Filter Tabs of the Qwik
Lock™ Filter in each hand.
2. With one thumb on the Qwik Lock™
Stud, which protrudes through
the integrated Filter Plate, lift up on the
Filter Tabs while pushing down on
the Stud.
3. This action will cause the Filter
to release from the Filter Cage.
Slide Filter off Cage.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the Filter before using the Vac for dry
material pick-up.
Filter Installation:
1. Carefully slide the Qwik Lock™ Filter
over the Filter Cage and press down
on the outside edge of the Filter until
the Rubber Gasket on the bottom of
the Filter seats securely around the
base of the Filter Cage and against
the Powerhead Assembly.
Qwik
Lock™
Stud
Filter
Cage
Rubber
Gasket
(Bottom of
Filter)
PUSH
DOWN
PULL
UP
Filter
Tabs (2)
Integrated Filter Plate
with Center Hole
PULL
UP
Float
Powerhead
Assembly
2. Align the small Center Hole in the top
of the Filter over the Qwik Lock™
Stud on the Filter Cage. Press firmly
on top of the Filter near the Stud to
allow the Filter to snap over the Ball
on the end of the Stud. The Filter is
now attached.
NOTE: Failure to properly seat the
Bottom Gasket could result in debris
bypassing the Filter.
WARNING: Do not operate
without Filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
!
Filter Cleaning
Your Filter should be cleaned often to
maintain peak Vac performance.
SP6852-2 Workshop 14 Gallon.qxp_WS1400CA0 8/27/18 3:37 PM Page 13

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Workshop WS1400CA and is the answer not in the manual?

Workshop WS1400CA Specifications

General IconGeneral
BrandWorkshop
ModelWS1400CA
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals