WORKZONE TITANIUM PREMIUM HC520 - Safety Guidelines; Personal Protection and Tool Safety

14
Safety informaon
condions must be fullled to ensure fault-free operaon of the electric tool.
– Damaged protecve devices and parts must be properly repaired or replaced
by a recognised workshop, insofar as nothing dierent is specied in the
operang manual.
– Damaged switches must be replaced at a customer service workshop.
– Do not use any faulty or damaged connecon cables.
– Do not use any electric tool on which the switch cannot be switched on and
o.
15 Have your electric tool repaired by a qualied electrician
– This electric tool conforms to the applicable safety regulaons. Repairs may
only be performed by an electrician using original spare parts. Otherwise
accidents can occur.
16 Important!
– For your own safety you must only use the accessories and addional units
listed in the operang instrucons or recommended or specied by the
manufacturer. The use of mounted tools or accessories other than those
recommended in the operang instrucons or catalogue may place your
personal safety at risk.
17 Noise
– Wear ear mus when you use the compressor.
18 Replacing the power cable
– To prevent hazards, leave the replacement of damaged power cables strictly
to the manufacturer or a qualied electrician. There is a risk of electric shock!
19 Inang res
– Directly aer inang res, check the pressure with a suitable pressure gauge,
for example at your lling staon.
20 Roadworthy compressors for building site operaons
– Make sure that all lines and ngs are suitable for the maximum permissible
operang pressure of the compressor.
21 Place of installaon
– Set up the compressor on an even surface.
22 Supply hoses at pressures above 7 bar should be equipped with a safety cable
(e.g. a wire rope).