USA
13Amp 7-1/4in. Circular Saw
14
AFTER SALES SUPPORT
USA
acs@americancustomerservice.com
Symbols & Warning
WARNING
Always ensure that the tool is switched off and the plug is
removed from the power point before making any adjustments
or maintenance procedures.
Always we ar sturdy gloves when handling or changing blades as they can
be very sharp.
Keep the tool’s air vents unclogged and clean at all times.
Regularly check to see if any dust or foreign matter has entered the grills
near the motor and around the trigger switch. Use a soft brush to remove
any accumulated dust. Wear safety glasses to protect your eyes whilst
cleaning.
Re-lubricate all moving parts at regular intervals.
If the body of the saw needs cleaning, wipe it with a soft damp cloth.
A mild detergent can be used but nothing like alcohol, petrol or other
leaning agent.
Never use caustic agents to clean plastic parts.
The label on your tool may include the following symbols:
LASER RADIATION DO NOT
STARE INTO BEAM
CLASS 2 LASER PRODUCT
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your local
authority or retailer for recycling advice.
LASER RADIATION
DO NOT STARE INTO BEAM
Maximum output < 1 mW, Wavelength: 650 nm/<1mW
CLASS II LASER PRODUCT
CAUTION/ATTENTION
To reduce the risk of injury, user must read and understand
instruction manual.
To Next Page
Loading...
