First use
14
1. Take the lamp out of the packaging.
2. Check whether the package contents are complete (see Fig.A and B).
3. Check whether the lamp or the individual parts exhibit damages. If this is the case,
do not use the lamp. Contact the manufacturer at the service address specified on
the warranty card.
Before start-up
If you would like to use the lamp without the adapter cord, you must first charge the
rechargeable battery of the lamp. The rechargeable battery is located in the handle of
the lamp. Charging takes 3 to 4 hours. You can charge the lamp via the socket or the
cigarette lighter of a vehicle.
NOTICE!
Risk of damage!
Improper handling of the lamp may damage it.
− Always switch the lamp off during the charging process.
1. Completely unwind the adapter cord.
2. Pull the lamp apart.
3. Plug the micro USB plug
7
of the adapter cord
9
into the micro USB port
13
of the lamp (see Fig. C).
4. Plug the USB plug
8
of the adapter cord into the power adapter
11
or the car
adapter
10
.
To avoid any discharging of the car battery, the manufacturer recom-
mends charging the lamp via a socket.
5. Connect the power adapter to a socket or the car adapter in the cigarette lighter of
a car.
6. The charging indicator
12
lights up red while the rechargeable battery is
charging.
7. As soon as the charging indicator turns green, the rechargeable battery is com-
pletely charged. Disconnect the lamp from the power supply when this happens.
The lamp features built-in protection against overcharging. Always
disconnect the lamp from the power supply as soon as it is fully
charged.
To Next Page
Loading...
Need help?
General