Operation
15
Operation
The lamp features 1 LED on the front side
4
and 1 LED on the top side
1
. The LED
on the top side can be tilted to the side (see Fig. D).
The lamp also features a total of 3 magnets on the base
2
, meaning that you can
attach the lamp to metal surfaces.
The light sources (LEDs) are not replaceable. If the lamp sources are defective, the en-
tire lamp must be replaced.
You can use the lamp with or without a connection to electric power. If the recharge-
able battery is not completely charged, meaning you would like to use the lamp with
a connection to electric power, proceed to follow the instructions in the next chapter.
Using lamp with connection to electric power
WARNING!
Fire hazard!
Parts of the lamp become hot during use. Improper handling of the
lamp may cause a fire.
− If you notice any smoke or smells of burning while using,
remove the adapter from the socket or cigarette lighter imme-
diately.
1. Completely unwind the adapter cord.
2. Plug the micro USB plug
7
of the adapter cord
9
into the micro USB port
13
of the lamp.
3. Plug the USB plug
8
of the adapter cord into the power adapter
11
or the car
adapter
10
.
4. Connect the power adapter to a properly installed socket or the car adapter in the
cigarette lighter of a car.
5. Switch on the lamp by following the instructions in the chapter “Using lamp with-
out a connection to electric power/Switching on the lamp”.
To Next Page
Loading...
Need help?
General