AUS
HCE2400 Safety regulations
AFTER SALES SUPPORT
15
1300 855 831
support@scheppach.com.au
MODEL: HCE2400 PRODUCT CODE: 62005 09/2018
• The electrical installation shall be according to national wiring rules.
• The device must only be connected to a mains socket via a residual-current circuit
breaker (RCD) with a rated leakage current of not more than 30 mA. Fuse: at least
13 ampere.
• Before each use, check the high pressure washer, cable and plug for damage.
• If the power cable for this high pressure washer is damaged, it must be replaced
by the manufacturer, a customer service agent of the same or a similarly qualied
person in order to prevent hazards.
• Do not pull the plug from the socket by the cable. Protect the cable from heat, oil
and sharp edges.
• Do not carry or x the high pressure washer by the cable.
• Use only extension cables that are protected from spray water and designed for
outdoor use. Always fully unroll a cable drum before use. Check the cable for
damage.
• Before any work on the high pressure washer, during work breaks and in the case
of non-use, remove the plug from the socket.
• Wear sturdy footwear to protect against electric shock.
• To protect against electric shock, operate the high pressure washer only in an
upright position.
High pressure washer safety warnings
Risk of unsafe operation
• Unsafe operation of your high pressure washer could lead to serious injury or
death to you or others.
• The spray gun/wand is a powerful cleaning tool that could look like a toy to a
child.
• Reactive force of spray results in gun/lance movement, potentially causing the
operator to slip, fall or misdirect the spray. Improper control of gun/wand can
result in injuries to self, others and property damage.
• Become familiar with the operation and controls of the high pressure washer.
To Next Page
Loading...